Surface Mining - Design Bench Pit

Moderator: Carlson Support

Surface Mining - Design Bench Pit

Postby KFinlay1 » Thu Jun 24, 2021 1:16 pm

Hey All,

I'm getting my feet wet with the Surface Mining Module and I design a lot of quarries/pits mostly by hand (well by 3D polylines). I'd like to get good at the Design Bench Pit function in the Surface Mining Module however I'm running into some issues I was hoping someone could shed light on. In the attached picture there are vertical turquoise lines that create a very tall wall that are impractical adjacent to my ramp. Is there anyway to control these? Thanks in advance.
You do not have the required permissions to view the files attached to this post.
KFinlay1
 
Posts: 1
Joined: Wed Jun 23, 2021 5:00 pm
Location: 33614

Return to Mining

Who is online

Users browsing this forum: No registered users