Making a grid file with faults.
Posted: Tue Nov 04, 2008 9:53 pmIn the geology module I am trying to make a grid file with multiple faults. I have the faults in one layer, each 3D poly-lines with each vertex representing the offset differential. The faults are drawn in the direction such that from start to end the left side is the down side of the fault.
My problem is that when i go to create the grid, and enter my cell size, check-box for faults, select my drill holes, then the command line prompts me to select my faults. i select them and it says that 0 are found 0 total each time. I've tried this multiple times and even re-booted.
Any suggestions?
Thank you.
My problem is that when i go to create the grid, and enter my cell size, check-box for faults, select my drill holes, then the command line prompts me to select my faults. i select them and it says that 0 are found 0 total each time. I've tried this multiple times and even re-booted.
Any suggestions?
Thank you.