I'd like to know if there is a specific setup 'file' for a Sokkia SET 500 to be used with SurvCE 2.5 on a Carlson Surveyor?
Currently use a generic setup file for this TS, but I often get annoying error messages when going in and out of the Backsight setup routine.
Although I am confident the setting of the backsight is correct, I would rather not get the messages!
Note: I use the SET-X model and was wondering there is a setup file for a SET-500 specifically.
The annoying error message is "Unable to send parameters..." and it only happens when I go into the Backsight setup procedure.