Carlson Software Forum

Posted: **Fri Jul 22, 2005 8:41 pm**

In our software that we used previously ( TDS ) there was a Inverse - Byline
command that told you how far a point was off of a designated line between
two points. Is there a way to do this in SurvCE?

Posted: **Sat Jul 23, 2005 4:04 am**

Toby B wrote:

In our software that we used previously ( TDS ) there was a Inverse - Byline
command that told you how far a point was off of a designated line between
two points. Is there a way to do this in SurvCE?

It's under Cogo -> Point Projection -> Line (or Centerline file)

Carlson Software Forum

Inverse

Inverse

Re: Inverse