by joshlkeene » Mon Jan 14, 2008 9:29 pm
I recently set up SurvCE on my Carlson Explorer 600+ to connect to a Sokkia Set 630R EDM. I've managed to make a connection between the two devices, and the Bluetooth connection icon on the MEAS screen of the EDM indicated an active connection. However, whenever I go to the Surv menu and attempt to take a reading or check my backsite angle, it shows "taking reading #1" for about ten seconds, followed by an error screen reading "error reading data." I'm still fairly new to using this, so any suggestions at all would be greatly appreciated.