Hello,
I need to upgrade my data collector and software, and was thinking of the SurvCE program. However, after looking at it, I cannot figure out how to stake a line with an elevation at the two ends. (I do NOT want to use points with elevations associated with them) - (Sewer Line staking) How do you stake a line (and change the elevation at either end of the line whenever you want).
Can curves do this?
The current staking program I use is "Surveyors Toolkit" made for the HP48gx. Got a new computer and there is NO SERIAL PORT!!!!, they are going away.
You define a horizontal alignment by point numbers, give stationing at each end.
Then define a vertical alignment by the stationing.
I can redefine the vertical alignment anytime.
After a stored reading, a C/F is given. If chosen I can enter another design elevation and another C/F is given.
Can SurvCE do this,and how???
________
volcano digital