Hello Carlson
I have switched from another data soft on a Husky FS3
and am currently studying the operation of SCE 2.30.60
Offset staking looked like a good starting point to try some
desk top bench survey with the robot ( gps does not work
well under the office roof)
As a test case the H alignment started at 120.10
H alignment end at 270.20
profile started at 200.00
profile ended at 400.00
I inputted into Check Sta field of Input-edit profile screen
a stn of 160 to be outside the profile limits
output was hoped to be plank of type XX.XX
as a indication of no profile data available
unfortunately a El:-0.800
stn 170 outputted a El:-0.600
it seems that the profile is being extended outside the
defined vert profile limits
for example stn 199.9 generated a elevation -0.02
In the live screen of offset stake Z:-0.02
Note stn 200.00 Z=0.00
Is it possible to clear Z: if no profile Z info is available ?
in both check sta and live screen of offset stake
As a example another test profile limits
XX.XX
Start stn 200
stop stn 400
XX.XX
restart stn 500
end stn 550
XX.XX
Thanks
Peter K