Carlson Software Forum

When I upgraded to SurvCE 2.53 my Sokkia rover began logging raw data as soon as it warmed up - no way to switch off or disable it. Since then I've upgraded to SurvCE 2.54 and the problem is still present. It's also upset the GPS Base, it logs static data for a while then stops - after anything from 15 mins to an hour.

SurvCE is loaded on an Allegro CX data collector.

I know this is obvious and I am not trying to troll, but check if record raw data is checked in your settings menu. If not, try doing a factory reset on the receiver (hold down the power button for about 15 sec. until is says "factory reset"). This should do the trick