Error: Not receiving base corrections!

Moderator: Carlson Support

Error: Not receiving base corrections!

Postby reto » Fri Jan 10, 2014 12:34 pm

I've just started to use SurvCE 3.0 on a STONEX S7-G. Besides a number of successful point measurements, it happened more than once that the RTK-signal could not be received.

After the RTK-server (http://www.swispos.ch) has been successfully connected, the device tries to read the RTK stream but fails with the following error message: "Not receiving base corrections!".
Q) What exactly is the reason for this message, poor GPRS/RTK reception and/or inadequate GPS reception?

I haven't found any solution to fix this behavior consistently so far. However, one of the following actions helped most of the time:
- re-connect
- disconnect / reconnect RTK
- stop and restart SurvCE

What suprises me is the fact that quite often there is no workaround but to exit and restart SurvCE.
Q) Is this a known issue or am a I missing something?
Q) Is there an easier way to recover from that state?
reto
 
Posts: 2
Joined: Wed Jan 08, 2014 10:26 pm
Location: Switzerland

Re: Error: Not receiving base corrections!

Postby Jfrost » Fri Feb 07, 2014 11:52 pm

You may want to check if the firmware of your GPS needs to be updated.
Jfrost
 
Posts: 3
Joined: Thu Jun 20, 2013 3:55 pm
Location: Central Texas

Re: Error: Not receiving base corrections!

Postby survtech » Tue Mar 11, 2014 4:01 pm

How do you check your firmware status?
survtech
 
Posts: 8
Joined: Wed Jan 16, 2008 4:28 pm

Re: Error: Not receiving base corrections!

Postby reto » Fri Jun 20, 2014 11:15 am

What do you mean by firmware, firmware of the Stonex device or SurvCE version?
reto
 
Posts: 2
Joined: Wed Jan 08, 2014 10:26 pm
Location: Switzerland


Return to SurvCE General

Who is online

Users browsing this forum: Google [Bot]