Page 1 of 1

Problem With Store Sections Routine

PostPosted: Tue Jun 10, 2008 8:32 pm
by jbrun
I am running SurvCE 2.04 on an Allegro CX with a Topcon 8003 robot. When I try to store a shot in this routine it tells me that there is an "Invalid Reading". However, at the bottom of the screen it is giving the exact location of where I am at and it changes as I move the prism. It does this when I hit the enter button or touch the "S" on the screen for store. Any suggestions?

PostPosted: Tue Jun 10, 2008 11:27 pm
by tstrickland
I'm using nearly the same setup as you, except for a GPT 825A. I get this often. I just take another shot and it usually works OK.

I have also been having a lot of trouble loosing bluetooth communication with the robot and gps. I spoke with John at Juniper Systems today about it. He said the registry in the Allegro may be getting corrupted, and suggested re-setting factory defaults on the Allegro. I'm going to try this tomorrow.

PS: I reset to system defaults today, and didn't have any communication problems with GPS, haven't tried it with the robot yet.