GPS base height stored as ref in monitor/skyplot
Posted: Mon Oct 19, 2015 7:01 pmI'm using Sokkia GSR2700 ISX base and rover with SurvCe 4.06 on an Allegro CX DC. If I input base co ords and height and then store the base as 'ref' point in monitor/skyplot the height value is higher than what was previously input. The difference is close to the height of the phase center above the ARP. RTK work is unaffected, ie heights are correct. Results are the same with 'NGS' antenna values box ticked or unticked.