Carlson Software Forum

I have attempted to run the "Convert AECC_POINTs to POINTS" (pt_aec) command.
This resulted in the following error:

Error1: Please install AEC Object Enabler first in order to run this command...

So... I downloaded Land 3 Object Enabler and installed it. I still get the same
error.

Any help would be appreciated.

Thank You,

Terrence Scanlon

Davis, Bowen, & Friedel, Inc.
tps@dbfinc.com

Terry Scanlon wrote:

Error1: Please install AEC Object Enabler first in order to run this command...

So... I downloaded Land 3 Object Enabler and installed it. I still get the same
error.

The conversion code was based on the object enabler code from LDD2i. It
appears there have been some changes in LDD3/OE3. The programmers in
the Boston office are looking into it.

Terry

Just so anyone else running into the problem knows. I did receive a fix for the
Land 3 Object Enabler.

Terry

"Terry Scanlon" <tpsx@dbfinc.com> wrote in message
news:74FEE5B80AD9D511A49800207811DE5446AF@24-216-164-75.hsacorp.net...

I have attempted to run the "Convert AECC_POINTs to POINTS" (pt_aec) command.
This resulted in the following error:

Error1: Please install AEC Object Enabler first in order to run this
command...

So... I downloaded Land 3 Object Enabler and installed it. I still get the
same
error.

Any help would be appreciated.

Thank You,

Terrence Scanlon

Davis, Bowen, & Friedel, Inc.
tps@dbfinc.com