Carlson Software Discussion Group
http://update3.carlsonsw.com/forum/
http://update3.carlsonsw.com/forum/viewtopic.php?f=20&t=1090
Posted: Thu Sep 05, 2002 10:43 pmPosted: Fri Sep 06, 2002 5:54 pmHow do I get the .inf file created by SurvCE to be saved in the same
directory as the .crd file and not always in the default data directory? I
would like to set up different directories for different jobs and keep all
of the files for each job together.
Posted: Thu Sep 12, 2002 2:00 amConfigure Survcad > General Settings > check the "Put Data Files in DWG
Directory"
"Kurt Tschanz" <kurt@csmgis.com> wrote in message
news:al886l$bgm$1@update.carlsonsw.com...
How do I get the .inf file created by SurvCE to be saved in the same
directory as the .crd file and not always in the default data directory?
I
would like to set up different directories for different jobs and keep
all
of the files for each job together.
Posted: Thu Sep 12, 2002 9:24 pmI was talking about the .INF file that is created by SurvCE not the .INI
file created by SurvCADD. Does anyone know how to change this setting in
SurvCE?
"Dave C." <dcc@geosurv.com> wrote in message
news:alabli$nhe$1@update.carlsonsw.com...
Configure Survcad > General Settings > check the "Put Data Files in DWG
Directory"
"Kurt Tschanz" <kurt@csmgis.com> wrote in message
news:al886l$bgm$1@update.carlsonsw.com...
How do I get the .inf file created by SurvCE to be saved in the same
directory as the .crd file and not always in the default data
directory?
I
would like to set up different directories for different jobs and keep
all
of the files for each job together.