Draw Polyline by coordinates

[davejr]

In older versions of Carlson, I could type "PL" then "10000,10000" to
start my polyline at that coordiantes. How do you do it now?



##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.general
##-----------------------------------------------##

[dr]

Dave,

Not sure what version you are comming from and assume you are now using
2007 standalone. Type PL to initiate the PolyLine command - this brings up
the "Polyline 2D options" dialog box (in the standalone software). Once we
have set this dialog boxes options up to satisfy our work we hit OK, now
we can input the coordinates for the beginning point of the line as
desired (1000,1000). If using a w/AutoCAD software version, just after
typing PL the command alows us to input the coordinates right away. Please
respond if this information is incorrect.

Dr


davejr wrote:

In older versions of Carlson, I could type "PL" then
"10000,10000" to
start my polyline at that coordiantes. How do you do it now?

##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.general
##-----------------------------------------------##

##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.general
##-----------------------------------------------##