Carlson Software Forum

I have been watching the Download website for the new update for GisCE,
and now the category is completely gone. Maybe Carlson is getting ready
to release it (fingers crossed)?
terry

I hope Carlson gives us the ability to "go to" a point in the next
release of GisCE. It works pretty good, other than that. The only way
that I've found is to store a point and inverse to get a bearing & distance.

Terry Strickland wrote:

I have been watching the Download website for the new update for GisCE,
and now the category is completely gone. Maybe Carlson is getting ready
to release it (fingers crossed)?
terry