point file
Moderator: Carlson Support
2 posts
• Page 1 of 1
point file
by courtney » Tue Jan 04, 2011 11:07 pm
I want to make the decimal place of my elevations land on the insertion point of the point. How can I do this?
- courtney
- Posts: 1
- Joined: Tue Jan 04, 2011 11:03 pm
by Dent Cermak » Wed Jan 05, 2011 1:27 am
In Survey 2010; go to POINTS pull down; 5th Line down, check "Elevation text only" and "Elevation label decimal on point".
Double check where it places the text. The exact location will vary by text size. In most cases I have to move the text a tad to the left. You can do a mass move command to move all of the spot shots the same amount.
Double check where it places the text. The exact location will vary by text size. In most cases I have to move the text a tad to the left. You can do a mass move command to move all of the spot shots the same amount.
- Dent Cermak
- Posts: 486
- Joined: Fri Mar 28, 2008 6:54 pm
- Location: Clinton, MS
2 posts
• Page 1 of 1
Return to General Carlson Discussion
Who is online
Users browsing this forum: No registered users