Real-Time Sphere View Mode (IntelliCAD)
Posted:
Wed Feb 16, 2011 11:04 pmby noliver
I really like this viewing mode for rotating the drawing, but I cannot figure out how to set the center of rotation (or if it's even possible). When I start this viewing mode it seems to set the rotation point to zero elevation at the center of the screen, which is very cumbersome because all of my drawings are set to true elevation (3000-5000ft). If anyone can point me in the right direction it would be greatly appriciated.
Posted:
Thu Feb 17, 2011 2:55 pmby site admin
Please copy this question and send it to
support@carlsonsw.com and I will see if I can get it to programming for a closer look. Thank you.
Bharris
Carlson Software
Technical Support
Posted:
Fri Feb 25, 2011 6:58 pmby noliver
Just figured it out! In the IntelliCAD menus SETTINGS>ELEVATION it allows you to set the value of the default drawing elevation, also setting the elevation the sphere veiw mode centers on.
Although it would be better if I could pick a point on the screen for a rotation center, this will do for now.