Carlson Software Forum

My C&G suddenly went to demo mode without me knowingly changing anything. It has worked fine on this machine for the past 3 or 4 years. I thought the lock may have went bad, but I changed with another computer and it work there and the one off that machine would not.

Any ideas?

PS: using Acad14 on an xp machine.

Thanks

I would suspect that it has to do with the hardware lock device & driver needed to run the program.

The Sentinel system driver should be installed & rebooted to get it running again.

if you can located the driver, Call C&G tech Support to email you a driver for Windows XP

1-800-367-1157 or email me at bwilson@carlsonsw.com

best wishes,
Barry Wilson
C&G Software Division