I have spent that last number of hours trying to insert text, from word
processing programs, into an Intellicad drawing. I have downloaded the
appropriate support document from C&G's tech support site. To no particular
avail. The best I have come up with is using MTEXT. However, as you may
know, you can't do anything with the text once its within the drawing. The
other method I tried (INSERT command) did indeed insert the document into
the drawing but it shows up as black text on a white backround (just as it
appeared in the word processing software) all against the black drawing
backround. What I want to do is insert the TEXT from a word processing
document onto the face of my drawing, not insert the document itself, as a
block (apparently).
Any ideas?
Chuck Sharp