Multiple Offset
Posted: Fri May 06, 2005 4:38 am
Is there a way to do a multiple offset (example: drawing steps they are
usually 0.9' apart and there are 8 to 10 of them). Is there a quick and
easy way to do a multiple offset?
I found an add-in for ACAD at (http://www.caddee.com/qoffset.html) that
does it but I don't know where to put it to work with C&G.
Can anybody offer any help/suggestions? Maybe a multiple offset command
in future releases (put that on the wishlist, John).
- Jon
Jonathan C. Lang, RPLS
Lang & Associates, inc.
11500 Daryl Avenue
Anchorage, Alaska 99515-3049
(907) 522-6476 Phone
(907) 522-4625 Fax
jclangls@alaska.net E-mail
usually 0.9' apart and there are 8 to 10 of them). Is there a quick and
easy way to do a multiple offset?
I found an add-in for ACAD at (http://www.caddee.com/qoffset.html) that
does it but I don't know where to put it to work with C&G.
Can anybody offer any help/suggestions? Maybe a multiple offset command
in future releases (put that on the wishlist, John).
- Jon
Jonathan C. Lang, RPLS
Lang & Associates, inc.
11500 Daryl Avenue
Anchorage, Alaska 99515-3049
(907) 522-6476 Phone
(907) 522-4625 Fax
jclangls@alaska.net E-mail