Carlson Software Forum

I'm working on a rather complex topo with lots of clutter. All of a sudden, when I zoom it never zooms to the area I selected. Also, when trying to pick entities, it never picks where the cursor is. Anyone know what is going on? This is driving me nuts

Stacy,
The zoom problem could be a result of a ucs or dview twist. To check, type ucs then enter then w and enter. If cursor is tilted you are in a dview twist. If so type dview enter, all enter, return angle to zero. This could also be affecting the cursor pick problem. Or if picking non C&G items go to options, graphic options, and set selection mode to none. Hope this helps, Jeff and I will be back in the office Monday

I have periodically had this same problem and the above did not resolve this issue. Would you have anything new or has anyone else had this problem?<br

Wouldn't you know I tried it again (not sure what I did yet) and it worked. Thanks anyway :