Page 1 of 1
No X axis or Y axis in Windows XP
Posted:
Mon Jun 10, 2002 10:22 pmby Brad
I loaded version 5.10.13 in Windows XP. All is
fine except that I have no X axis, Y axis or Z axis lines. I tried loading the intellicad program again, but no difference. Any idea whats going on? All of axis or different colors
Re: No X axis or Y axis in Windows XP
Posted:
Tue Jun 11, 2002 2:08 amby jeff
Have you checked your settings under drawing settings
Re: No X axis or Y axis in Windows XP
Posted:
Tue Jun 11, 2002 12:15 pmby Brad
Yes, no luck. I am finding out that it may be
a video problem. I am running windows XP with a intel pentium 4 2.0ghz 256mb ram with intergrated intel video. Has anyone had problems with intergrated video and intellicad 98?
Thanks for you help.
<br
Re: No X axis or Y axis in Windows XP
Posted:
Wed Jun 12, 2002 1:41 amby Jeff
Brad crank down your hardware ecelorator found by going to start then control panel then printers and other hardware on the right side then look to the left for display. This brings up the display properties box you want the last tab or settings once in that tab go to advanced and then to trouble shoot and you will be looking at the hartdware acceloprator setting crank here down some (to the left), worked like a champ for me i am about half way
Re: No X axis or Y axis in Windows XP
Posted:
Wed Jun 12, 2002 1:04 pmby Brad
Very Smart, Thanks it did the trick