Carlson Software Forum

When I select anything to find its properties, I have no problem being
able to look at the properties. The problem lies in when I go back to
the drawing from the properties window, whatever I have selected becomes
dashed. It stays dashed until I regen the drawing. Then when I zoom or
pan it still is dashed. The only way to get rid of the dashing is to
select something else to find the properties of . Then that becomes
dashed and what ever was dashed becomes fine and that is now dashed.
Whats going on????

I have the same problem - you have to regen or something to get the
ghosting to go away. I gave this problem to C&G in Atlanta on Monday -
have not heard anything back.


PETER LAMB wrote:

When I select anything to find its properties, I have no problem being
able to look at the properties. The problem lies in when I go back to
the drawing from the properties window, whatever I have selected becomes
dashed. It stays dashed until I regen the drawing. Then when I zoom or
pan it still is dashed. The only way to get rid of the dashing is to
select something else to find the properties of . Then that becomes
dashed and what ever was dashed becomes fine and that is now dashed.
Whats going on????

Initial findings is that this is an intellicad bug. Suggested work
around,
from other users, is to place a bogus "junk" line in the drawing and
select
it so that it is the highlighted line. I haven't heard back from the
programmers yet. I will update you after discussing this with them.


--
Barkley Hensley, P.L.S.
Tech Support Manager
Carlson Software
email - bhensley@carlsonsw.com


"Mark Ware" <pls5031@pacbell.net> wrote in message
news:3D6E142C.7090401@pacbell.net...
I have the same problem - you have to regen or something to get the
ghosting to go away. I gave this problem to C&G in Atlanta on Monday -
have not heard anything back.


PETER LAMB wrote:

When I select anything to find its properties, I have no problem being
able to look at the properties. The problem lies in when I go back to
the drawing from the properties window, whatever I have selected
becomes
dashed. It stays dashed until I regen the drawing. Then when I zoom
or
pan it still is dashed. The only way to get rid of the dashing is to
select something else to find the properties of . Then that becomes
dashed and what ever was dashed becomes fine and that is now dashed.
Whats going on????