Copy entities from one drawing to another.

[Richard Preiss]

I could do this under Intellicad but cannot seem to figure out how to do
this in 6.0.

Help . . . anyone?

[Richard Preiss]

Just figured it out. Used Copy to Clipboard from first dwg and then Paste
from clipboard into second dwg.

Only needed to use the copy command before if two drawings were open at the
same time.


"Richard Preiss" <preiss@csolve.net> wrote in message
news:bmi4e9$mkg$1@update.carlsonsw.com...

I could do this under Intellicad but cannot seem to figure out how to do
this in 6.0.

Help . . . anyone?