We coordinate new building corners using CGMngmt>Manual Storage quite a bit,
using snaps on the lines and corners.
Sometimes we go back to make a change to a point and the software allows
over-writing of the point with no warning.
Sometimes this is good but most times it is bad as the software then
defaults to that point number and it is quite easy to unintentionally
over-write the next point(s).
In other words, say you coordinated points 1250 to 1299 and then went back
(within the manual storage command) and edited point 1253. The next point
the software wants to coordinate becomes 1254! If you are not careful, all
your newly created points from 1254 to 1299 will be overwritten without a
warning from the software.
Is there a way for the software to warn you that you are about to over-write
a point within the Manual Storage command? (Also withion the Automatic
Storage command?)