Carlson Software Forum

Hello guys,

We use a description code system. We have all curb and pavement shots plot
with a +. This aids in cleaning up your drawing.

After the initial plot, I want to change all of those points to just dots. I
cant find a way to do that. In the DOS version it was a "GLOBAL" change.

Any help would be appreciated.

--
D. Michael North, P.L.S.
True Line Company, Land Surveyors
TN # 2370 AL # 26008
Phone: 423/825-1045
Fax: 423/821-2818

Hey Mike,
We're putting the Global Change function back into C&G in the next
release, but in the meantime you'll have to do it another way. Isolate the
layer(s) that contain the points. Under Drawing Settings, change the symbol
to a dot. Then you should replot those points using the Plot Points on
Screen command. Choose "Select" as your point selection method and you can
graphically pick those points from the screen. Give me a shout if you have
a problem.
John


--
John W. VanMeter
Carlson Software
C&G Division
800-367-1157
"CG Survey" <mikenorth@truelinesurvey.com> wrote in message
news:c90hdb$hv4$2@update.carlsonsw.com...

Hello guys,

We use a description code system. We have all curb and pavement shots plot
with a +. This aids in cleaning up your drawing.

After the initial plot, I want to change all of those points to just dots.
I
cant find a way to do that. In the DOS version it was a "GLOBAL" change.

Any help would be appreciated.

--
D. Michael North, P.L.S.
True Line Company, Land Surveyors
TN # 2370 AL # 26008
Phone: 423/825-1045
Fax: 423/821-2818