Carlson Software Forum

Is there anyway to set CG 7.0 so that it automatically goes to that file
when you open a drawing/coordinate file/ raw data file, etc. It seems like
it takes forever everytime I do something to get to the right file. Sort of
like the Dos version where you set the path and everything is good to go
from there.

Under the CG Options pulldown, you can set the data path for a
particular drawing.

Sam Clemons wrote:

Is there anyway to set CG 7.0 so that it automatically goes to that file
when you open a drawing/coordinate file/ raw data file, etc. It seems like
it takes forever everytime I do something to get to the right file. Sort of
like the Dos version where you set the path and everything is good to go
from there.

Thanks Stacy, I found it.