Lot File Report Issues

[roxy]

Hello,

I'm a fairly new user to the Carlson Software, my question today is how do
I get get the traverses in my lot file report to update after having moved
points in my dwg.

I have already used the Coordinate File Utilities commands in order to
update my dwg. but that has not worked. My linework anno currently being
shown since moving the points does not match my lot file report.

What am I missing?

Thx


##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##

[JJR]

I have never used that feature, but after your post I decided to check it
out. Whenever I moved a point using the "mpnt" command, which updates the
..crd file, my report and subsequent lotlines came out correctly, all
updated. Unfortunately this means I did not duplicate your problem. Are
you using a command which updates the .crd file? Are you creating the lot
using points or a polyline? The following is a .lot file created by using
points, which appears to have successfully updated every time. (Sorry about
all caps, but that is the output format.) And just so you know it is very
easy with this software to move a point's attributes but not move the point
in the .crd file. (We have someone in the office who learned that the hard
way.) Since the .lot file depends on the .crd file, it wouldn't update. It
sounds like you may have done that but I am just guessing. Let us know more
if this is not helpful.

LOT_NAME|1
LOT_TYPE|LOT
BLOCK_NAME|1
START_STA|0.000
CRDFILE|L:\SURVEY JOBS\Waterville\WATERVILLE.crd
PT|482|LINE
PT|483|LINE
PT|484|LINE
PT|485|LINE
PT|482|LINE

[jcorsaro]

roxy wrote:

Hello,

I'm a fairly new user to the Carlson Software, my question today is how
do
I get get the traverses in my lot file report to update after having
moved
points in my dwg.

I have already used the Coordinate File Utilities commands in order to
update my dwg. but that has not worked. My linework anno currently
being
shown since moving the points does not match my lot file report.

What am I missing?

Thx

Update the drawing .crd file by selecting the points that were moved and
re run the report
jim

##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##

##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##