Best Fit Arc

[mark baker]

In 2007 StandAlone when I chose Best Fit Arc it would hold the endpoints, but in 2013 it changes the endpoints. How do I hold the endpoints (no change) and calculate the radius of the curve using the cl poc's between the endpoints? Thanks.

MB

[Streek]

DRAW - ARC - BEST FIT CURVE

The end points must existing and be points.
Then if you have at least 3 points along your "proposed" arc, it will prompt for them, after the 2 end points.

It then holds the end points and adjusts the arc to best fit.

[mark baker]

Thanks. That is the way my 07 worked but with 2013 it draws the best fit arc but does not hold the endpoints which are coordinate points. I may have a setting wrong.

MB

[Streek]

Very Strange.

Now I go into the SAME file and it does what you describe, and I can't get it to work the other way again.


I must have messed up the same setting you did!

[mark baker]

I checked with tech support and that feature is not offered in 2013. Programming is going to add that feature in 2015.

MB