Field to Finish Help

[ROBERTS2]

I am trying out Carlson Survey 2006. I import points and connect using
field to finish, works great. I then do draw-locate and screen pick some
points. These points are between some inported points with the same code.
When I then do F2F it ignores the placed points completely and just draws
the line to the imported points. Why is it not using the screen picked
points in drawing the line, even when they have the same code (i.e. TC1)?

Thanks
Rob


##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##

[ROBERTS2]

Tes, it was as simple as that. I didn't even see the point range. Thank
you very much.

John Macolini wrote:

I don't know for sure - but it sounds like you're creating linework by
using
the codes, and connecting by Nearest Found.

If that is the case, then after inserting the new points, when you run
FTF,
you just need to make sure that your Range of Points includes the new
point
numbers, and it should draw to these points.

"ROBERTS2" <ROB@SALITSURVEY.COM> wrote in message
news:dvl0td$gaq$1@update.carlsonsw.com...

I am trying out Carlson Survey 2006. I import points and connect
using
field to finish, works great. I then do draw-locate and screen pick
some
points. These points are between some inported points with the same
code.
When I then do F2F it ignores the placed points completely and just
draws
the line to the imported points. Why is it not using the screen
picked
points in drawing the line, even when they have the same code (i.e.
TC1)?

Thanks
Rob


##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##

##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##

[John Macolini]

I don't know for sure - but it sounds like you're creating linework by using
the codes, and connecting by Nearest Found.

If that is the case, then after inserting the new points, when you run FTF,
you just need to make sure that your Range of Points includes the new point
numbers, and it should draw to these points.

"ROBERTS2" <ROB@SALITSURVEY.COM> wrote in message
news:dvl0td$gaq$1@update.carlsonsw.com...

I am trying out Carlson Survey 2006. I import points and connect using
field to finish, works great. I then do draw-locate and screen pick some
points. These points are between some inported points with the same code.
When I then do F2F it ignores the placed points completely and just draws
the line to the imported points. Why is it not using the screen picked
points in drawing the line, even when they have the same code (i.e. TC1)?

Thanks
Rob


##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##