Carlson Software Forum

Posted: **Mon Oct 25, 2004 5:41 pm**

Welcome

Are there any Carlson commands that will calculate an arc (or TP, CP, IP
points) if I only have a two lines and an tangent distance?
What if for some strange reason I only have a two lines and an arc length -
is there a command to make an arc?

The AutoCAD fillet command only works with a radius.

Thanks in advance

Posted: **Wed Oct 27, 2004 8:20 am**

Try '2TANLTL'

Under draw, curves, 2 tangents,tangent length

"Stephen Rhodes" <stephen.rhodes@fyfe.com.au> wrote in message
news:cliufh$qt6$1@update.carlsonsw.com...

Welcome

Are there any Carlson commands that will calculate an arc (or TP, CP, IP
points) if I only have a two lines and an tangent distance?
What if for some strange reason I only have a two lines and an arc
length -
is there a command to make an arc?

The AutoCAD fillet command only works with a radius.

Thanks in advance

Posted: **Sat Oct 30, 2004 4:51 am**

Thanks
"Andrew Puller" <andrew@surveyor.net.au> wrote in message
news:cln7ft$k2p$1@update.carlsonsw.com...

Try '2TANLTL'

Under draw, curves, 2 tangents,tangent length

"Stephen Rhodes" <stephen.rhodes@fyfe.com.au> wrote in message
news:cliufh$qt6$1@update.carlsonsw.com...
Welcome

Are there any Carlson commands that will calculate an arc (or TP, CP, IP
points) if I only have a two lines and an tangent distance?
What if for some strange reason I only have a two lines and an arc
length -
is there a command to make an arc?

The AutoCAD fillet command only works with a radius.

Thanks in advance

Carlson Software Forum

Carlson Curve commands?

Carlson Curve commands?

Re: Carlson Curve commands?

Re: Carlson Curve commands?