Carlson Software Forum

When drawing cross sections is there any way to make the vertical lines two
different line types such as:

Whole foot (100) lines can be created as solid lines

Half foot (100.5) lines be created as dashed or dotted lines to make it
easier to distinguish the elevation at the lines?

I don't see a way for this to happen but it does sound like a good idea. I
will see if it is something that we can get added.

Jason Dumas
Carlson Software
Technical Support Team
606-564-5028 ex 313
"Justin Brungard" <jbrungard@hrico.com> wrote in message
news:d6vkuh$9qg$1@update.carlsonsw.com...

When drawing cross sections is there any way to make the vertical lines
two
different line types such as:

Whole foot (100) lines can be created as solid lines

Half foot (100.5) lines be created as dashed or dotted lines to make it
easier to distinguish the elevation at the lines?