Endpoint Leaders

[Harley Pawley]

Is there a way to get this command to put the leaders at the endpoints
instead of just near?

Currently, this command creates a sloppy mess when multiple leaders are used
for different directions from the same point.

[John Macolini]

Annotate/Annotate Defaults/Draw Leaders to Endpoints.


"Harley Pawley" <harleyp@alphasub.com> wrote in message
news:denm10$kdi$1@update.carlsonsw.com...

Is there a way to get this command to put the leaders at the endpoints
instead of just near?

Currently, this command creates a sloppy mess when multiple leaders are
used
for different directions from the same point.

[John Macolini]

Also make the Offset Scaler = 0


"John Macolini" <jmacolini.aci@verizon.net> wrote in message
news:devfs0$529$1@update.carlsonsw.com...

Annotate/Annotate Defaults/Draw Leaders to Endpoints.


"Harley Pawley" <harleyp@alphasub.com> wrote in message
news:denm10$kdi$1@update.carlsonsw.com...
Is there a way to get this command to put the leaders at the endpoints
instead of just near?

Currently, this command creates a sloppy mess when multiple leaders are
used
for different directions from the same point.

[Harley Pawley]

Thank you very much, John. I thought I had tested the settings on that one,
but obviously not!

Harley

"John Macolini" <jmacolini.aci@verizon.net> wrote in message
news:devg0g$560$1@update.carlsonsw.com...

Also make the Offset Scaler = 0


"John Macolini" <jmacolini.aci@verizon.net> wrote in message
news:devfs0$529$1@update.carlsonsw.com...
Annotate/Annotate Defaults/Draw Leaders to Endpoints.


"Harley Pawley" <harleyp@alphasub.com> wrote in message
news:denm10$kdi$1@update.carlsonsw.com...
Is there a way to get this command to put the leaders at the endpoints
instead of just near?

Currently, this command creates a sloppy mess when multiple leaders
are
used
for different directions from the same point.