Carlson Software Discussion Group
http://update3.carlsonsw.com/forum/
Posted: Fri Aug 26, 2005 10:16 pmPosted: Mon Aug 29, 2005 9:17 pmIs there a way to get this command to put the leaders at the endpoints
instead of just near?
Currently, this command creates a sloppy mess when multiple leaders are
used
for different directions from the same point.
Posted: Mon Aug 29, 2005 9:20 pmAnnotate/Annotate Defaults/Draw Leaders to Endpoints.
"Harley Pawley" <harleyp@alphasub.com> wrote in message
news:denm10$kdi$1@update.carlsonsw.com...
Is there a way to get this command to put the leaders at the endpoints
instead of just near?
Currently, this command creates a sloppy mess when multiple leaders are
used
for different directions from the same point.
Posted: Fri Sep 02, 2005 5:19 amAlso make the Offset Scaler = 0
"John Macolini" <jmacolini.aci@verizon.net> wrote in message
news:devfs0$529$1@update.carlsonsw.com...
Annotate/Annotate Defaults/Draw Leaders to Endpoints.
"Harley Pawley" <harleyp@alphasub.com> wrote in message
news:denm10$kdi$1@update.carlsonsw.com...
Is there a way to get this command to put the leaders at the endpoints
instead of just near?
Currently, this command creates a sloppy mess when multiple leaders
are
used
for different directions from the same point.