Carlson Software Forum

I'm trying to design a shape on the ground for which I have the Azimuth's of
some lines, the distances of most lines and the relitive angles of some
lines.
My quandry is how to draw a line by entering the South Azimuth of the line
and the distance of the line.

Under the cogo pulldown toggle on the Line ON/OFF option. Under the
Settings pulldown go to Configure > General Settings. Toggle on South
Azimuth. Have a go at this and see if it helps, hope so.


Raziel wrote:

I'm trying to design a shape on the ground for which I have the Azimuth's of
some lines, the distances of most lines and the relitive angles of some
lines.
My quandry is how to draw a line by entering the South Azimuth of the line
and the distance of the line.