Carlson Software Forum

I have several drawings where the contours were created with LDD and the
rest of the drawing was created with Carlson Survey. Is there a way to get
the tin data and the breaklines from LDD into CS? I know that I can
recreate a tin from the contours but I really need the original tin with
the original breaklines. The reason the drawings were done this way is
that we are in a transition phase. We ar going from LDD to CS for our
survey dept.

Thanks



##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##

Carlson Survey 2006>Surface>Contour from Tin file

"Wayne Wolfe" <mwwolfe@gulftel.com> wrote in message
news:dg79ce$uud$1@update.carlsonsw.com...

I have several drawings where the contours were created with LDD and the
rest of the drawing was created with Carlson Survey. Is there a way to get
the tin data and the breaklines from LDD into CS? I know that I can
recreate a tin from the contours but I really need the original tin with
the original breaklines. The reason the drawings were done this way is
that we are in a transition phase. We ar going from LDD to CS for our
survey dept.

Thanks



##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##