Carlson Software Forum

Posted: **Fri Sep 16, 2005 7:46 pm**

Has anyone noticed that after performing a buffer offset, the normal offset
routine creates a buffer offset?
Closing and reopening the drawing seems to remedy the problem, but I don't
care to do that every time if another fix is out there.
-Jay

Posted: **Fri Sep 16, 2005 9:56 pm**

Works fine in Carlson Survey 2006.

"BSS" <Survey@suscom-maine.net> wrote in message
news:dgepbm$hpq$1@update.carlsonsw.com...

Has anyone noticed that after performing a buffer offset, the normal
offset routine creates a buffer offset?
Closing and reopening the drawing seems to remedy the problem, but I don't
care to do that every time if another fix is out there.
-Jay

Posted: **Sat Sep 17, 2005 10:04 am**

That occurs also in Carlson Survey 2006.
I will get this reported to the programmers.
Work around:
After buffer offset type VAREDIT at command line and enter value 0 for
OFFSETGAPTYPE or Settings>Set Environment Variables>OFFSETGAPTYPE>Value>0

"Nava Ran" <navaran@zahav.net.il> wrote in message
news:dgf0vk$mh6$1@update.carlsonsw.com...

Works fine in Carlson Survey 2006.

"BSS" <Survey@suscom-maine.net> wrote in message
news:dgepbm$hpq$1@update.carlsonsw.com...
Has anyone noticed that after performing a buffer offset, the normal
offset routine creates a buffer offset?
Closing and reopening the drawing seems to remedy the problem, but I
don't care to do that every time if another fix is out there.
-Jay

Carlson Software Forum

Offset after buffer offset

Offset after buffer offset

Re: Offset after buffer offset

Re: Offset after buffer offset