Carlson Software Forum

When I use the wall3d and a height with a decimal point included the decimal component is not recognized. An additional point is created in the default layer with the description as the decimal fraction. For example wall3d5.8 will create a 3d face 5 high and create a point with description 8. The command is only reading to the whole number. I have not tried it with the other 3d operations. This happens in embedded 2009 and intellicad 2009

wall3d+5.8 will work

thanks

the 3d codes are very clever additions. I have produced a very advanced 3d model straight from FF with only some simple editing of the crd file.

Use flyby command to visualise what you have created.