Hatch Command
Posted: Wed Jul 08, 2009 5:17 pmMy hatch command under my draw menu will not load correctly, any suggestions to correct the problem?
Thanks
Thanks
Carlson Software Forum
Carlson Software Discussion Group
http://update3.carlsonsw.com/forum/
Hatch Command
Page 1 of 1
Posted: Wed Jul 08, 2009 5:17 pmPosted: Mon Jul 13, 2009 3:25 pmWhat's happening when you select the command? Which version are you running?
Posted: Mon Jul 13, 2009 6:06 pmI’m running 2009. From the draw menu I select hatch. It loads a boundary hatch menu with three tabs, boundary, pattern properties and pattern. Under boundary I select area, select a closed figure in the drawing, the menu reappears and that’s all. It will not follow through with the ok button on the bottom of the menu. Also under patterns it lists all the hatches but does not preview them in the display windows.
Thanks
Thanks
Posted: Mon Jul 13, 2009 8:12 pmPlease go to the Help pull-down menu and report the build date in (xxxxxx)? Also, can you go back to Help and then About Intellicad to get the version off of the second line of text there? Thank you.
As far as the previews not showing up for the hatches, right click on your desktop and go to Properties. Click on the Settings tab, click the Advanced button and then go to the Troubleshoot tab. In here, turn the Hardware acceleration to NONE. You may need to restart after this to get the correct results.
Thank you.
As far as the previews not showing up for the hatches, right click on your desktop and go to Properties. Click on the Settings tab, click the Advanced button and then go to the Troubleshoot tab. In here, turn the Hardware acceleration to NONE. You may need to restart after this to get the correct results.
Thank you.