Carlson Software Forum

Is there a way to offset to a certain layer in Carlson Survey 2006? In
Autocad I used a lisp routine to do this. All I had to do was set my
layer as current and all offsets would be to this layer. I would like to
save the step of having to change the layer of the offset items. Thanks.

Terry Watson said the following on 2/6/2006 12:36 PM:
Is there a way to offset to a certain layer in Carlson Survey 2006? In
Autocad I used a lisp routine to do this. All I had to do was set my
layer as current and all offsets would be to this layer. I would like
to save the step of having to change the layer of the offset items.
Thanks.

If CS uses the core AutoCAD offset command, then yes. Look at the
options on the command line.


That option does not show up on the command line in Carlson Survey 2006.

That option does not show up on the command line in Carlson Survey 2006.