Carlson Software Forum

Using Carlson Survey 2006, is there any way to draw a profile by selecting
the 3D polyline? I have found a way around this by creating points on the
polyline, but I would like to just select the 3D polyline and see the
profile.



##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##

Surface>Profile from Pts on Centerline...

"j_wes_cole" <j_wes_cole@yahoo.com> wrote in message
news:e0e91c$4ll$1@update.carlsonsw.com...

Using Carlson Survey 2006, is there any way to draw a profile by selecting
the 3D polyline? I have found a way around this by creating points on the
polyline, but I would like to just select the 3D polyline and see the
profile.



##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##

Just type pro3dpl at the command line - it should work.
There is no help or menu item for this using Carlson Survey 2006.

Regards...Stephen.

"j_wes_cole" <j_wes_cole@yahoo.com> wrote in message
news:e0e91c$4ll$1@update.carlsonsw.com...

Using Carlson Survey 2006, is there any way to draw a profile by selecting
the 3D polyline? I have found a way around this by creating points on the
polyline, but I would like to just select the 3D polyline and see the
profile.



##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##