Hatch on boundary area

[TLEng_sg]

Hello,

I try to input a select Hatch for my boundary area. Is it possible to do that?

1) I try to set my polyline with "Draw --> boundary polyline"

2) i go to "Area/Layout" under "Lot Network Setting" , i set the hatch pattern i want to appear on my boundary.

3) However, after i "hatch boundary area" under the "lot network boundary", the hatch does not show to be what i want.

Please assist me with this.. Thank you..

[site admin]

Perhaps what you are looking for is "Hatch" under the Draw pulldown. If this doesn't get you going, please email your question to support@carlsonsw.com or give us a call at 606-564-5028. Thank you.

Carlson Software