Carlson Software Forum

Hello,

I try to input a select Hatch for my boundary area. Is it possible to do that?

1) I try to set my polyline with "Draw --> boundary polyline"

2) i go to "Area/Layout" under "Lot Network Setting" , i set the hatch pattern i want to appear on my boundary.

3) However, after i "hatch boundary area" under the "lot network boundary", the hatch does not show to be what i want.

Please assist me with this.. Thank you..

Perhaps what you are looking for is "Hatch" under the Draw pulldown. If this doesn't get you going, please email your question to support@carlsonsw.com or give us a call at 606-564-5028. Thank you.

Carlson Software