I'm working on a project that started off in an assumed coordinate system and at the conclusion of the field work I recieved UTM coordinates of some nearby control. I tied the control that I set with the known control and now I need to rotate & translate my topography from assumed to UTM. Using the help menu I found a description for "Combined Transfortmation" but could not locate it from any of the menus ( points,survey,etc. ) Does anyone know where this can be located? I was also watching one of the webinars which used the "Adjust Coordinates" menu from the "points" drop down. Are these bacically the same commands?
Any help is greatly appreciated.
Thanks
Erik