I pick points with elevation for streets, building pads, and ponds.
1. Whats the easiest way to change Elevation on a single point? It's easier to pick points along the curb line and then come back and enter elevations.
2. How do you get "Z" value to work on lines? In CAD 2010 I could draw a line between two contours, and then pick a point say at the midpoint of the line and the new point would plot W/elev. I can not get lines to draw in with Z value at all.
Most everything else appears to be the same so far. Almost all commands are the same except I can not find "locate point" I used that to find an elevation using nearest along a line with beg/end elevations.