Carlson Software Forum

I have installed Survey 2007 for AutoCAD 2006 and am having a problem with
the curve table command. On the defaults list I have checked the options I
want (1. Radius, 2. Delta Angle, 3. Tangent, 4. Arc Length, 5. Chord Length,
6. Chord Angle). When the curve table is generated, it shows options 1-5,
but it doesn't give me the Chord Bearing. Any ideas?

J. R. Faulk
Dividing Line Survey Services

J.R.,

Try taking off the 6th option and letting the block get redefined. Try it
and see if all 5 items display, if so go back and set the 6th item again.
Try again. If it fails go to a new empty drawing and try it there. If it
works there, insert the problem drawing into the new empty drawing and try
again. Let me know how it goes.

"J.R. Faulk" <jrfaulk@dividingline.biz> wrote in message
news:eep4c7$8p6$1@update.carlsonsw.com...

I have installed Survey 2007 for AutoCAD 2006 and am having a problem with
the curve table command. On the defaults list I have checked the options I
want (1. Radius, 2. Delta Angle, 3. Tangent, 4. Arc Length, 5. Chord
Length, 6. Chord Angle). When the curve table is generated, it shows
options 1-5, but it doesn't give me the Chord Bearing. Any ideas?

J. R. Faulk
Dividing Line Survey Services