Carlson Software Forum

Not a make or break situation, just trying to stick to my familiar looks.

Whenever I start a new drawing and am going to import/draw some field survey points, I always have to go into POINTS --> POINT DEFAULTS and change the default symbol (from SPT4 to SPT10).

I also go to POINTS --> POINT UTILITIES --> CHANGE POINT LAYER/COLOR and adjust to my preferred colors.

Is there any way to adjust these then save the settings to automatically load up each time I start a new drawing?

Thanks

I think if you do this in your template drawing it would take care of it.
Create your point layer in it, also, and select the color you want.