blocks?
Posted:
Thu Jan 17, 2013 12:29 pmby Streek
Carlson 2013 w/ embedded ACAD
How do I show a list of blocks in the current drawing?
In ACAD it was BLOCKenter ? it took 2 seconds.
Re: blocks?
Posted:
Thu Jan 17, 2013 3:01 pmby Dent Cermak
Your Surv.pgp file is evidently set to give you the option window on the block command. So, try entering -block on the command line. After the "minus" block command you will get ENTER BLOCK NAME. Enter the ?. Then at ENTER BLOCKS TO LIST enter *.
Note this will also include any blocks that you have listed in your *.dwt file, so for an accurate lise, purge all of the unused block definitions before using -block.
Re: blocks?
Posted:
Fri Jan 18, 2013 2:23 pmby Nava Ran
Draw>Insert will show you the list of blocks