Page 1 of 1
Best Fit Arc
Posted:
Tue Feb 11, 2014 7:12 pmby mark baker
In 2007 StandAlone when I chose Best Fit Arc it would hold the endpoints, but in 2013 it changes the endpoints. How do I hold the endpoints (no change) and calculate the radius of the curve using the cl poc's between the endpoints? Thanks.
MB
Re: Best Fit Arc
Posted:
Wed Feb 12, 2014 2:10 pmby Streek
DRAW - ARC - BEST FIT CURVE
The end points must existing and be points.
Then if you have at least 3 points along your "proposed" arc, it will prompt for them, after the 2 end points.
It then holds the end points and adjusts the arc to best fit.
Re: Best Fit Arc
Posted:
Wed Feb 12, 2014 3:05 pmby mark baker
Thanks. That is the way my 07 worked but with 2013 it draws the best fit arc but does not hold the endpoints which are coordinate points. I may have a setting wrong.
MB
Re: Best Fit Arc
Posted:
Wed Feb 12, 2014 3:42 pmby Streek
Very Strange.
Now I go into the SAME file and it does what you describe, and I can't get it to work the other way again.
I must have messed up the same setting you did!
Re: Best Fit Arc
Posted:
Wed Feb 26, 2014 11:15 amby mark baker
I checked with tech support and that feature is not offered in 2013. Programming is going to add that feature in 2015.
MB