Is it possible to block point numbers and elevations togethe

Moderator: Carlson Support

Is it possible to block point numbers and elevations togethe

Postby JaceTx » Thu Feb 13, 2014 9:12 pm

I often move my points numbers with the elevations and descriptions around to clear up the drawing.

Is it possible to have them blocked together as I plot them? I dont mean all the points blocked together I mean have each point blocked with its own elevation and description together.


It would make it a lot easier to move them around.

Thanks
JaceTx
 
Posts: 1
Joined: Thu Feb 13, 2014 4:57 pm
Location: Texas

Re: Is it possible to block point numbers and elevations tog

Postby Dent Cermak » Thu Feb 13, 2014 9:28 pm

Under SETTINGS, down to "Carlson Settings", them pick the first radio button"General Settings". On that pop-up check "Group Point Entities".
To move the point blocks, go to POINTS and down to "Move Point Attributes With Leader". You can then move the point block without corrupting your coordinate file and it gives you a nice leader line back to the point node. (Once you erase the points from the drawing and then reload then, all of the point blocks will be back at the nodes.)
Dent Cermak
 
Posts: 486
Joined: Fri Mar 28, 2008 6:54 pm
Location: Clinton, MS


Return to Survey

Who is online

Users browsing this forum: No registered users